I think if you "push" the spot prime, total prime and painting over spots repaired with quick dry (or any) drywall compound without waiting the required and re-coat time - I suspect (my observation only - I'm not a chemist......) that the "surface tension" caused from the shrinkage of subsequent coats of paint will pull blisters in the weakened and softened mud, which hasn't had the chance to dry out properly between coats. Because of this "suspicion", I have implemented rule #2.
Rule #2: Prime all drywall compounds with drywall primer and wait the required amount of time before re-coating.
The porosity of these primers I suspect, allows the compound to dry out faster by releasing the water (and any "out gassing" with hot mud) more readily through the porous films of these primers. After spot priming with the PVA primer (and allowing it to dry properly) then a tighter film primer such as the satin sheen universal primers can be used as a total surface primer before top coating or paperhanging.
Note: When doing drywall repair, there is no excuse for not removing the sanding dust. Vacuum, tack rag (use micro fiber type of tack rag - not the oil rag type) or dust off the sanding dust. Don't add another variable to the equation. Yes, the primer might wet the dust - but it might not, so don't take a chance
Painting and Decorating Concourse Home > Drywall Repair and Finishing > Chemical Setting Compounds Part 2
Our "terms of use" governs your use of our website; by using our website, you accept this disclaimer in full. If you disagree with any part of our "terms of use", do not use our website.
There is another reason which I believe causes paint blistering on hot compounds (actually over any type of joint compound). When you prime over any compound, you "re-wet" the compound and temporarily "weaken" or soften it. Just take a wet rag to some compound that you slopped on some hardware or counter top etc.. and it will easily dissolve away once wetted.
 | ||||
Again this rule isn't rocket science, but if you follow it impeccably, you will save yourself a lot of grief. Let me expand on this rule a bit. I never use satin (sheen) latex paints or satin (sheen) latex primers over drywall compound. The PVA primers designed for drywall compounds are flat and breath better than satin sheen primers/paints.
Dustless Drywall Sanding
Sanding Attachments / HEPA Filters
The best painting tools at great prices ….. are just one click away
click here
| ||||
Quick Setting Drywall Compounds pt.2
Search This Site
| ||||
Custom Search
| ||||
The
Concourse eStore
| ||||
| ||||
| ||||
| ||||
| ||||
| ||||
SM
Painting Tips and Advice
| ||||
Painting and Decorating Concourse
| ||||
| ||||
| ||||
